Ashtech Z-FX Manuel de service télécharger pdf (Page 41)

Getting Started 29

Getting Started

This chapter describes receiver operations available through the front panel.

Memory Card

This section applies only to the Z-Surveyor.

While you may use the Z-Surveyor without a memory card, one is required for internal

data storage.

Installation

Perform the following steps to properly insert the PCMCIA card.

1. Orient the Z-Surveyor so that you are looking at the front panel.

2. Open the memory bay door on the front of the Z-Surveyor.

3. Orient the PCMCIA card so the arrow on the label is on the bottom side of card

and pointing towards the memory card slot.

Figure 3.1: Opening Memory Bay Door

PCMCIA Card Slot

PCMCIA LED

Slot Filler

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 93 94

Pas de commentaire

Ashtech Z-FX Manuel de service Page 41