Ashtech Z-FX Manuel de service télécharger pdf (Page 43)

Getting Started 31

Getting Started

7. Close and seal the memory bay door on the front of the Z-Surveyor.

Removal

Perform the following steps to remove the PCMCIA card.

1. Ensure recording has stopped (either issue a “stop session” through the front

panel, or issue a $PASHS,REC,S command, or turn the receiver off).

2. Orient the Z-Surveyor so that you are looking at the front panel.

3. Open the memory card bay door on the front of the Z-Surveyor.

Whenever you stop data recording to insert a new PCMCIA card, data recording will resume as soon

as the new card has been inserted, recognized as valid, and the system has verified there is enough

memory to continue data recording.

Figure 3.3: Memory Bay Door Closing

CAUTION

Attempting to extract a PCMCIA card while LED is flashing might result in

loss of up to five minutes of recorded data or render the card completely

unreadable (corruption of internal file structure). Wait until LED no longer

flashes to remove card.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 93 94

Pas de commentaire

Ashtech Z-FX Manuel de service Page 43